I developed a sort of "warming blanket" setup to go above the bed.


You will need: a 4-meter length of cord, a 4x4 m tarp, and a 2.1 x 1.5 m "woobie" (poncho liner/blanket). See photos below.


Instructions – see photo below.


Run the cord lengthwise, positioned above the middle of the bed at a height of about 60 cm. Secure one end of the cord to something outside the bed area.


Thread the cord through three of the tarp’s attachment loops, leaving a portion of the tarp hanging freely at both ends.


Attach a thin wire to those three tarp loops, and thread the other end of the wire through the reinforcements of the tarp’s loops—this allows you to hang the "woobie" blanket (using its own ties) from the wires, underneath the tarp.


Then, pull the tarp (which is now doubled over) and the enclosed "woobie" blanket across to the other side of the bed.


Because the "woobie" blanket hangs freely from the cord, it causes the tarp to curve inward, as shown in the photo.


You then sleep underneath this setup.


Since the tarp is made of nylon—which is impermeable to both air and moisture—a large air pocket is trapped between the two layers of the tarp; air can only escape from this pocket very slowly. This air pocket is warmed by your own body heat. The quilted "woobie" blanket, situated between the tarp layers, absorbs this heat and releases it gradually. As a result, it stays very warm underneath that air pocket.


However...


There is an extra half-meter of material at both ends of the tarp. You fold them over the ends of the bed as shown in the picture, and secure them so they stay in place—see the image.


Why do it this way?


Because you don’t want cold air entering the tarp through any gaps. However, as warm air rises from within the tarp, it meets the incoming air and warms it up.


In other words, there must be no openings at either end of the tarp, as that would compromise the warmth inside.


The advantage of my design is that the tarp is double-layered, with a heat-retaining "woobie" blanket sandwiched between the layers—that’s what provides the warmth.


Furthermore, if you set this up in the woods with a campfire or a wood stove in front of it, the heat is transferred into the pocket of air behind the person lying inside. In a forest setting, you must also bury the edges of the tarp in a small trench in the ground to ensure there are no gaps for air to flow underneath and into the tarp—this is absolutely essential.


So, I think it’s fair to say that this is the warmest—and truly the lightest—tarp design ever developed.


Give it a try.







Kommentit

Tämän blogin suosituimmat tekstit

Searching instrumentalist to be feat artist to my improvisations